R&S ZNB Series User Manual page 913

®
R&S ZNB/ZNBT
CALCulate:FMODel:ISD:FTIMe:OVERride <Boolean>
If set to true, the flight time for DUT + lead-in is specified using
ISD:FTIMe:DUT. Otherwise, it is calculated automatically.
True is equivalent to setting the leadin_dut_time batch mode parameter of the ISD
tool to auto.
Parameters:
<Boolean>
Manual operation:
CALCulate:FMODel:ISD:IMPedance <Boolean>
Enables/disables the impedance correction of the ISD tool.
This is a global setting.
Parameters:
<Boolean>
Manual operation:
CALCulate:FMODel:ISD:OPERation <Operation>
Defines the execution mode of the ISD tool.
Parameters:
<Operation>
Manual operation:
CALCulate:FMODel:ISD:PASSivity <Boolean>
Defines whether the ISD tool shall enforce passivity and reciprocity for the test cou-
pons and the test fixture.
Corresponds to the passive batch mode parameter of the ISD tool.
Parameters:
<Boolean>
Manual operation:
User Manual 1173.9163.02 ─ 62
See "Auto. flight time for DUT + lead-Ins"
ON (1)
Impedance correction enabled
OFF (0)
Impedance correction disabled
See "Use Impedance Correction"
FAST | ACCurate
ACCurate: normal execution mode
FAST: reduces the execution time to ~50%
In many cases the FAST mode can be enabled with only little
loss of accuracy.
See "Operation (fast/acc)"
ON (0): enforce passivity and reciprocity
OFF (0): do not enforce passivity and reciprocity
See "Enforce Passitivity"
Command reference
SCPI command reference
CALCulate:FMODel:
on page 636
on page 629
on page 638
on page 637
913