R&S ZNB Series User Manual page 978

Vector network analyzers
Table of Contents

Advertisement

®
R&S
ZNB/ZNBT
Example:
Usage:
Manual operation:
CALCulate<Chn>:RIPPle:DATA <RippleLimRange>...
Adds and enables/disables an arbitrary number of ripple limit ranges, assigning the
stimulus values and the ripple limits. See
tion",
Note: This command does not overwrite existing ripple limit ranges. The defined
ranges are appended to the range list as new ranges. Use the
CALCulate<Chn>:RIPPle:SEGMent<Seg>... commands to change existing ripple
limits.
Suffix:
<Chn>
Parameters:
<RippleLimRange>
User Manual 1173.9163.02 ─ 62
SWE:TYPE POW
Select a power sweep.
CALC:RIPP:CONT:DOM PLIN
Delete all existing ripple limit ranges and select level units for the
domain of the active trace.
CALC:RIPP:DATA 1, -10, -5, 3
Define and enable a ripple limit range in the stimulus range
between -10 dBm and -5 dBm, assigning a ripple limit of 3 dB.
Setting only
See
"Add / Insert / Delete / Delete All / Align All"
on page 147.
.
Channel number used to identify the active trace
Parameter list in the format <Type>, <StartStimulus>, <StopSti-
mulus>, <RippleLimit>[, {<Type>, <StartStimulus>, <StopStimu-
lus>, <RippleLimit>}], where:
<Type> – Boolean identifier for the ripple limit range type. 1 for
ripple limit range on (with limit check). 0 for ripple limit range off:
The range is defined, but no limit check result displayed. The
result is still available via
SEGMent<Seg>:RESult?.
<StartStimulus>/<StopStimulus>– stimulus values (unitless) con-
fining the ripple limit range
<RippleLimit> – ripple limit (unitless) in the stimulus range
between <StartStimulus> and <StopStimulus>
The unit of a stimulus value is adjusted to the sweep type of the
active channel ([SENSe<Ch>:]SWEep:TYPE), the unit of a rip-
ple limit is adjusted to the format of the active trace
(CALCulate<Chn>:FORMat).
Range:
*RST:
Chapter 4.4.1.2, "Rules for ripple test defini-
CALCulate<Chn>:RIPPle:
Virtually no restriction for ripple limit ranges.
n/a (no ripple limit line defined after a reset)
Command reference
SCPI command reference
on page 385
978

Advertisement

Table of Contents
loading

Table of Contents