Table of Contents
Advertisement
®
R&S
ZNB/ZNBT
Note: If either multiple DUTs are configured (see
Measurement
ted channel (see
inactive (grayed out).
Multiple DUTs...
Opens a dialog that allows you to set up the analyzer for parallel measurements on
multiple DUTs. See
on page 570.
5.12.2.2
Port Settings dialog
The "Port Settings" dialog is an example of a
selected channel, it configures the source and receiver ports of the R&S ZNB/ZNBT for
arbitrary frequencies, source and receiver levels.
Access: Channel – [Channel Config] > "Port Config" > "Port Settings..."
Related information
Refer to the following sections:
●
Chapter 4.7.4, "Frequency conversion
●
Chapter 5.18.4.2, "External Power Meters
●
Chapter 5.18.4.4, "External Generators
Arb Frequency tab
Defines port-specific frequencies (arbitrary mode) and other port-specific source set-
tings.
Arbitrary mode requires software option R&S ZNB/ZNBT-K4, see
quency conversion
User Manual 1173.9163.02 ─ 62
dialog",
on page 570) or the "Fixture Simulator" is disabled for the rela-
"Fixture Simulator"
on page 549), the "Balanced Ports..." button is
Chapter 5.12.2.3, "Define Parallel Measurement
measurements",
on page 236.
Channel Config softtool
Chapter 5.12.2.3, "Define Parallel
Multi-channel setup
measurements",
on page 236
dialog",
on page 780
dialog",
on page 785
GUI reference
dialog",
dialog. For the
Chapter 4.7.4, "Fre-
562
Advertisement
Chapters
Table of Contents
