R&S ZNB Series User Manual page 680

®
R&S ZNB/ZNBT
With "Ok" you proceed to the final
cards the import definition.
Step 3: Select S-parameters ← Add/Insert
In the final step, you select the S-parameter data you actually want to overwrite. The
GUI is described in
numbers refer to the physical VNA ports (not the data file ports).
Select at least one trace to enable the "Ok" button. Selecting "Ok" applies, selecting
"Cancel" discards your import definition.
Delete/Delete All
Deletes the selected or all additional imports.
Export snp
Allows you to export the active channel's complete VNA S-Matrix into a single Touch-
stone file.
The S parameters defined by additional imports are summarized on the
Matrix Overview
specific, or global simulation data.
For a possible application, see
5.14.7.2 Resulting S Matrix Overview tab
The "Resulting S Matrix Overview" tab summarizes the S parameters defined by addi-
tional imports. See
The remaining S parameters that are required for the channel simulation are taken
from the channel-specific, setup-specific, or global simulation data (see
tion Data..."
User Manual 1173.9163.02 ─ 62
Step 2: Assign alias ports from
Chapter 5.5.11.3, "Select Parameter
tab. The remaining ones are taken from the channel-specific, setup-
"Performance aspects"
Chapter 5.14.7.1, "Configure Additional Imports
on page 677).
GUI reference
File softtool
file, "Cancel" dis-
dialog", on page 371. The port
Resulting S
on page 679.
tab", on page 678.
"Load Simula-
680