Table of Contents
Advertisement
®
R&S
ZNB/ZNBT
CALCulate<Chn>:EYE:MASK:SHAPe:BOTTom:HORizontal <Width>
CALCulate<Chn>:EYE:MASK:SHAPe:TOP:HORizontal <Width>
Defines the width of the bottom/top rectangle in the eye mask of the related eye dia-
gram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Use
EYE:MASK:SHAPe:TOP:STATe
The eye mask test is enabled/disabled using CALCulate<Chn>:EYE:MASK:STATe.
Suffix:
<Chn>
Parameters:
<Width>
Options:
Manual operation:
CALCulate<Chn>:EYE:MASK:SHAPe:BOTTom:STATe <Boolean>
CALCulate<Chn>:EYE:MASK:SHAPe:POLYgon:STATe <Boolean>
CALCulate<Chn>:EYE:MASK:SHAPe:TOP:STATe <Boolean>
Activates/deactivates the respective area in the eye mask of the related eye diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
The eye mask test is enabled/disabled using CALCulate<Chn>:EYE:MASK:STATe.
Suffix:
<Chn>
Parameters:
<Boolean>
Options:
Manual operation:
CALCulate<Chn>:EYE:MASK:SHAPe:BOTTom:VERTical <Offset>
CALCulate<Chn>:EYE:MASK:SHAPe:TOP:VERTical <Offset>
Defines the offset of the bottom/top rectangle in the mask of the related eye diagram.
The offset is specified relative to the vertical center of the eye mask (see
CALCulate<Chn>:EYE:MASK:CENTer:VERTical
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
User Manual 1173.9163.02 ─ 62
CALCulate<Chn>:EYE:MASK:SHAPe:BOTTom:STATe
.
Channel number used to identify the active trace
Default unit: s
R&S ZNB/ZNBT-K20
See
.
Channel number used to identify the active trace
*RST:
R&S ZNB/ZNBT-K20
See
to activate or deactivate the area in the eye mask.
"Top/Bottom Setup"
on page 706
OFF
"Top/Bottom Setup"
on page 706
Command reference
SCPI command reference
or
CALCulate<Chn>:
on page 871).
874
Advertisement
Chapters
Table of Contents
