R&S ZNB Series User Manual page 548

®
R&S ZNB/ZNBT
Active Channel
Selects an arbitrary channel of the active recall set as the active channel. This function
is disabled if the current recall set contains only one channel.
If one or several traces are assigned to the selected channel, one of these traces
becomes the active trace.
The order of all channels in a recall set is given by the channels' creation time. By
default, the channels are named Ch1, Ch2, ... so that Ch<n – 1> precedes Ch<n>. This
order is always maintained, even if channels are renamed, invisible (because no traces
are assigned to them) or distributed over several diagram areas.
Tip: You can also select a line in the channel list to activate the corresponding channel.
Remote command:
The numeric suffix <Ch> appended to the first-level mnemonic of a command selects a
channel as the active channel.
New Channel
Creates a channel and a trace with default settings, and assigns the new trace to the
active diagram area.
The new channel is named Ch<n>, where <n> is the largest of all existing channel
numbers plus one. The name can be changed in the "Channel Manager" dialog.
Tips:
●
To create a channel and a trace with default settings and to display the trace in a
new diagram area, use
●
Use
Remote command:
CONFigure:CHANnel<Ch>[:STATe]
CALCulate<Ch>:PARameter:SDEFine
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:FEED
CONFigure:TRACe<Trc>:CHANnel:NAME?
CONFigure:TRACe<Trc>:CHANnel:NAME:ID?
Copy Channel
Copies the active channel with all its settings (including a possible channel calibration)
and traces. The new traces are displayed in the active diagram area.
The new channel is named Ch<n>, where <n> is the largest of all existing channel
numbers plus one. The name can be changed in the "Channel Manager" dialog.
Tips: Use
area.
Remote command:
CONFigure:CHANnel<Ch>[:STATe]
CALCulate<Ch>:PARameter:SDEFine
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:FEED
CONFigure:TRACe<Trc>:CHANnel:NAME?
CONFigure:TRACe<Trc>:CHANnel:NAME:ID?
User Manual 1173.9163.02 ─ 62
New Channel +
Add Trace to create a trace in the active channel.
Copy Channel + Diagram
Diagram.
ON
to display the copied traces in a new diagram
ON
GUI reference
Channel Config softtool
548