R&S ZNB Series User Manual page 185

®
R&S ZNB/ZNBT
Example:
Select ports no. 1, 2, 3. A forward transmission normalization calibrates the S-parame-
ters S
ters S
mission S-parameters.
4.5.5.3 Characterization of calibration units
Each calibration unit is delivered with factory characterization data which ensure an
accurate calibration for all standard applications. For specific modifications of the test
setup, e.g. the connection of additional adapters to a calibration unit, a modified set of
characterization data (suitable for the cal unit with adapters) may be desirable. The
R&S ZNB/ZNBT provides a characterization wizard which you can use to generate
your own characterization data sets for (modified) R&S cal units. The characterization
data can be stored in the cal unit and used for automatic calibration whenever needed.
A cal unit characterization can be performed in a frequency sweep. The network ana-
lyzer must be properly calibrated, with the reference plane at the input ports of the
(modified) cal unit to be characterized.
The procedure involves the following steps:
1. Perform a calibration of your network analyzer, using the test setup and the calibra-
tion type you wish to perform with your calibration unit.
2. Connect the calibration unit to the network analyzer.
3. Access the "Characterize Cal Unit" dialog (Channel – [Cal] > "Cal Devices" >
"Characterize Cal Unit...") and select "Start Characterization...".
4. Step through the "Characterization" wizard, following the instructions in the dialogs.
Dependency between calibration types and characterization data
A cal unit characterization provides full one-port (OSM) data at the selected ports plus
two-port (Through) data between any pair of selected ports. The measurement of
Through data is optional, however, it is required for some calibration types. The follow-
ing table gives an overview.
Calibration type
Refl Norm Open
Refl Norm Short
Refl OSM
UOSM
TOSM
Trans Norm Both
Trans Norm Forward
One Path Two Ports
User Manual 1173.9163.02 ─ 62
, S , and S . A reverse transmission normalization calibrates the S-parame-
21 31 32
, S , and S . A bidirectional transmission normalization calibrates all six trans-
12 13 23
Concepts and features
Characterization data required
OSM CalPort 1, OSM CalPort2 ... (all calibrated
ports)
OSM CalPort 1, OSM CalPort2 ... (all calibrated
ports), Through (between all pairs of ports)
Calibration
185