R&S ZNB Series User Manual page 335

®
R&S ZNB/ZNBT
Add Tr+Diag
Creates a trace in the active channel and assigns it to a new diagram. Otherwise
behaves like
Remote command:
CALCulate<Ch>:PARameter:SDEFine
DISPlay[:WINDow<Wnd>][:STATe]
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:FEED
Delete Trace
Deletes the active trace and removes it from the diagram area. If the active diagram
contains only one trace, the diagram is also deleted.
"Delete Trace" is disabled if the active recall set contains only one trace. In manual
control, each recall set must contain at least one diagram area with one channel and
one trace.
Tips:
●
You can also hide traces without actually deleting them: remove the corresponding
"On" flags in the "Trace Manager" (see
on page 336).
●
Use the undo function to restore a trace that was unintentionally deleted.
Remote command:
CALCulate<Ch>:PARameter:DELete
CALCulate:PARameter:DELete:ALL
CALCulate<Ch>:PARameter:DELete:CALL
Diagram / Channel
Displays the active diagram and channel, i.e. the diagram and channel of the
Trace. Allows you to move the active trace to another diagram or channel.
Remote command:
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:FEED
Show <Trace Name> / Hide All Other Traces / Show All Traces
Configures the visibility of the traces in the active diagram:
●
"Show <Trace Name>" toggles the visibility of the
●
"Hide All Other Traces" hides all traces of the active diagram – except the active
one (which can be visible or not)
●
"Show All Traces" makes all traces of the active diagram visible
Note:
●
These actions can also be performed from the context menu of the trace name
segment in the trace list (see
on page 112).
●
Use the "On" flags in the "Trace Manager" to show/hide arbitrary sets of traces
(see
Disable all other Measurements/Enable all Measurements
Toggle button with alternating caption.
Same functionality as the
on page 57
User Manual 1173.9163.02 ─ 62
Add Trace.
Chapter 5.5.1.3, "Trace Manager
toggle button of the
ON
Chapter 5.5.1.3, "Trace Manager
Active Trace
Chapter 4.2.1.4, "Channel list and channel
dialog", on page 336).
Chapter 3.3.2.2,
GUI reference
Trace Config softtool
dialog",
Active
settings",
"Toolbar",
335