®
R&S
ZNB/ZNBT
Remote command:
SYSTem:AGC:GLOBal:METHod
Recovery tab
Provides a single function "Boot into Recovery Screen" that allows you reboot the
instrument and launch the "R&S Recovery Environment". From there you can restore
the original system image (including operating system and firmware).
See
HUMS tab
The "HUMS" tab allows you to enable and configure R&S HUMS (see
"Health and usage monitoring service
software option R&S ZNB/ZNBT-K980 is installed.
User Manual 1173.9163.02 ─ 62
Chapter 12.2, "System
recovery",
on page 1538.
(HUMS)",
on page 253). It is only available if
GUI reference
Setup softtool
Chapter 4.7.12,
763