R&S ZNB Series User Manual page 444

®
R&S ZNB/ZNBT
Sweep Controller
Activates/deactivates the (resizable) "Sweep Info" dialog, which displays the current
sweep stage. The "Sweep Info" dialog is particularly useful for long duration sweeps
that are executed in single sweep mode: by observing the dialog, it is easy to realize
when the sweep is done.
The possible sweep stages and how they are displayed partly depend on the selected
sweep mode (see
Sweep stage
No ongoing sweep
Sweep is being prepared
Ongoing sweep
Measurement results are being calculated
1) The VNA is sweeping or waits for a trigger signal.
Pipelining
Allows you to activate pipelining of measurement data for alternated
Chapter 4.1.4.2, "Pipelining of measurement
Remote command:
INITiate:PIPelining:STATe
(CALCulate:PIPelining:DATA?)
5.10.4.2 Restart Manager dialog
The "Restart Manager" dialog defines the
mode.
Access: Channel – [Sweep] > "Sweep Control" > "Restart Manager..."
Related information
Refer to
User Manual 1173.9163.02 ─ 62
"Continuous / Single"
1)
Chapter 4.1.4, "Sweep
on page 442):
Sweep controller display
in "Continuous" sweep
mode
Idle
Preparing
Continuous
Continuous calculation
data", on page 92.
Restart Sweep
control", on page 90.
GUI reference
Sweep Softtool
in "Single" sweep mode
Idle
Preparing
Sweeping
if #Sweeps = 1
Sweeping m/n
if n = #Sweeps > 1
Calculation
Driving Mode. See
behavior in "Single" sweep
444