R&S ZNB Series User Manual page 410

®
R&S ZNB/ZNBT
●
"Absolute Level:" The bandpass (bandstop) is the tallest (lowest) peak in the
search range. To be valid, the peak must be above (below) -"Bandwidth". The
Lower Band Edge and Upper Band Edge values are given by the frequencies
where the trace is equal to -"Bandwidth".
●
"None": "Bandfilter" search switched off, result off.
Remote command:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:BWIDth:MODE
Tracking
Causes the active "Bandfilter" search to be repeated after each sweep: When tracking
mode is active, the markers typically change their horizontal and vertical positions as
the measurement proceeds.
Tracking mode properties
Tracking modes are available for all search modes. The tracking modes for minimum/
maximum/peak search and target search are coupled; tracking for "Bandfilter" search
can be activated separately. Tracking is activated automatically when one of the "Band-
filter" search modes is selected.
Remote command:
"Bandfilter" tracking and marker/target search tracking are controlled with the same
command:
CALCulate<Chn>:MARKer<Mk>:SEARch:TRACking
5.7.7 Set by Marker tab
The "Set by Marker" functions use the active marker to define the sweep range, scale
the diagram and introduce an electrical length offset. The functions are unavailable if
the active trace contains no markers (e.g. after "All Markers Off").
Examples
Refer to
User Manual 1173.9163.02 ─ 62
Chapter 3.3.7.6, "Set by marker", on page 76.
GUI reference
Marker softtool
410