R&S ZNB Series User Manual page 710

®
R&S ZNB/ZNBT
Remote command:
CALCulate<Chn>:DTIMe:POSition
Extended Info
Defines whether the info field for the skew measurement shall only provide basic infor-
mation (default) or extended information:
Figure 5-81: Skew info, basic vs. extended
The displayed skew values are positive, if, at the defined
trace is to the right of the
Remote command:
CALCulate<Chn>:DTIMe:DATA?
Skew Check On
Enables the skew check with the specified
Remote command:
CALCulate<Chn>:DTIMe:LIMit:STATe
Skew Limit
Defines the limit value for the skew check. The unit depends on the current format of
the X axis (see
A TTL signal
Remote command:
CALCulate<Chn>:DTIMe:LIMit:LIMit
Global Check, TTL1 Pass, TTL2 Pass
see Chapter 5.6.1, "Limit Test
5.16.2.11 Time Gate tab
Replicates the "Time Gate" tab of the "Trace Config" softtool (see
Gate
Access: System – [Applic] > "TDR" > "Time Gate"
Since for the eye diagram, the time axis always equals two times the symbol time, the
display of the time gate range lines ("Show Range Lines") does not make sense, and is
therefore not available.
5.16.2.12 Y Axis tab
The "Y Axis" tab allows you to define the y axis scaling of the active diagram. The scal-
ing logic is the same as for all other diagram types, see
on page 328.
User Manual 1173.9163.02 ─ 62
Reference
" Time / Distance"
indicating pass or fail can be generated in addition.
tab", on page 353).
Trace.
Skew Limit.
on page 419).
tab", on page 373
GUI reference
Applic softtool
Skew Position, the active
Chapter 5.5.6, "Time
Chapter 5.4, "Scale softtool",
710