R&S ZNB Series User Manual page 847

®
R&S ZNB/ZNBT
Before the import, the target trace must be prepared according to the settings used
during export. Any request for new data from the hardware ("Restart Sweep" in sin-
gle sweep mode or switching to continuous sweep mode) discards imported data
and switches back the display to measured data.
Suffix:
<Chn>
Parameters:
<Data>
Parameters for setting and query:
<Format>
Example:
User Manual 1173.9163.02 ─ 62
.
Channel number used to identify the active trace
Trace data either in ASCII or block data format, depending on
the current
FORMat[:DATA]
FDATa | SDATa | MDATa | NCData | UCData | SCORr1 |
SCORr2 | SCORr3 | SCORr4 | SCORr5 | SCORr6 | SCORr7 |
SCORr8 | SCORr9 | SCORr10 | SCORr11 | SCORr12 |
SCORr13 | SCORr14 | SCORr15 | SCORr16 | SCORr17 |
SCORr18 | SCORr19 | SCORr20 | SCORr21 | SCORr22 |
SCORr23 | SCORr24 | SCORr25 | SCORr26 | SCORr27
See list of parameters below.
*RST; SWE:POIN 20
Create a trace with 20 sweep points, making the created trace
the active trace of channel 1 (omitted optional mnemonic
SENSe1).
CALC:DATA? FDAT
Query the 20 response values of the created trace. In the FDATa
setting, 20 comma-separated ASCII values are returned.
CALC:DATA:STIM?
Query the 20 stimulus values of the created trace. 20 comma-
separated ASCII values are returned.
CALC2:PAR:SDEF 'Trc2', 'S11'
Create a second trace in a new channel no. 2. The second trace
does not become the active trace and is not displayed.
CALC:DATA:TRAC? 'Trc2', FDAT
Query the response values of the second (non-active) trace. 20
comma-separated ASCII values are returned.
CALC:DATA:ALL? FDAT
Query the response values of all traces. 40 comma-separated
ASCII values are returned.
Command reference
SCPI command reference
setting.
847