R&S ZNB Series User Manual page 307

®
R&S ZNB/ZNBT
Remote command:
CALCulate<Ch>:PARameter:MEASure
"Y-S12" ...
CALCulate<Ch>:PARameter:SDEFine
"Y-S22" | ...
Y←S<out><in> softkeys
Selects the 2-port
admittances of a 2-port DUT, obtained in forward and reverse transmission and reflec-
tion measurements:
●
Y
the reference impedance Z
reflection measurement).
●
Y
the reference impedance Z
reflection measurement).
●
Y
respectively.
Use the Smith chart to obtain an alternative, graphical representation of the converted
impedances in a reflection measurement.
Tip: Use the "Y- Z-Params" tab to measure Y-parameters including the transfer param-
eters.
Remote command:
CALCulate<Ch>:PARameter:MEASure
"Y-S12" | "Y-S21" | "Y-S22"
CALCulate<Ch>:PARameter:SDEFine
"Y-S12" | "Y-S21" | "Y-S22"
Model
In case a transmission parameter is selected, you can choose between a
(default), and a
Remote command:
CALCulate<Ch>:PARameter:MEASure
"Y-S12SER" | "Y-S12PAR" | ...
CALCulate<Ch>:PARameter:SDEFine
"Y-S12SER" | "Y-S12PAR" | ...
Balanced Ports...
Opens a dialog to configure the logical ports of the analyzer.
See
User Manual 1173.9163.02 ─ 62
converted admittance
is the input admittance at port 1 of a 2-port DUT that is terminated at port 2 with
11
is the input admittance at port 2 of a 2-port DUT that is terminated at port 1 with
22
and Y denote the forward and reverse converted transfer admittances,
12 21
parallel admittance calculation.
Chapter 5.2.1.3, "Balanced Ports
"<Trace_Name>", "Y-S11" |
"<Trace_Name>", "Y-S11" |
parameters. The parameters describe the
(matched-circuit admittance measured in a forward
0
(matched-circuit admittance measured in a reverse
0
"<Trace_Name>", "Y-S11" |
"<Trace_Name>", "Y-S11" |
"<Trace_Name>", "Y-S12" |
"<Trace_Name>", "Y-S12" |
dialog", on page 289.
GUI reference
Meas softtool
series
307