R&S ZNB Series User Manual page 860

®
R&S ZNB/ZNBT
CALCulate<Chn>:EYE:DUT:MODE <DUTMode>
Allows to (temporarily) switch between the measured DUT and an ideal one (with flat
frequency response) in the related eye diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Suffix:
<Chn>
Parameters:
<DUTMode>
Options:
Manual operation:
CALCulate<Chn>:EYE:EMPHasis:CURSor:POST<1|2> <Weight>
Sets the weights of the post-cursor taps for the pre-emphasis FIR filter in the calcula-
tion chain of the related eye diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Emphasis in the generator simulation for eye diagram measurements is enabled using
CALCulate<Chn>:EYE:EMPHasis:STATe.
Suffix:
<Chn>
<1|2>
Parameters:
<Weight>
Options:
Manual operation:
CALCulate<Chn>:EYE:EMPHasis:CURSor:PRE <Weight>
Sets the weight of the pre-cursor tap for the pre-emphasis FIR filter in the calculation
chain of the related eye diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Emphasis in the generator simulation for eye diagram measurements is enabled using
CALCulate<Chn>:EYE:EMPHasis:STATe.
Suffix:
<Chn>
User Manual 1173.9163.02 ─ 62
.
Channel number used to identify the active trace
IDEal | MEASured
R&S ZNB/ZNBT-K20
See "Mode" on page 702
.
Channel number used to identify the active trace
1 for the "Post 1" filter tap, 2 for the "Post 2" filter tap.
Weight relative to the "Cursor" tap
*RST: 0 dB
Default unit: dB
R&S ZNB/ZNBT-K20
See "Cursor Settings"
.
Channel number used to identify the active trace
Command reference
SCPI command reference
on page 698
860