R&S ZNB Series User Manual page 474

®
R&S ZNB/ZNBT
The layout of the dialog panel depends on the number of test ports available.
Figure 5-26: Define Calibration dialog (manual, > 4 test ports)
Ports
Selects the test ports to be calibrated.
Note: Calibration and port de-/activation.
The analyzer fimware automatically activates/deactivates ports during/after a (success-
ful) calibration:
●
Calibrated ports that were previously disabled, are automatically enabled as single-
ended logical ports.
●
An uncalibrated port that is not used by a measurement (i.e. the port is not required
by any trace of the related channel) is disabled.
User Manual 1173.9163.02 ─ 62
GUI reference
Cal softtool
474