R&S ZNB Series User Manual page 999

®
R&S ZNB/ZNBT
CALCulate<Chn>:TRANsform:DTFault:SELect <DtfSelectCable>
Selects one of the available (predefined or user-defined) cable types for Distance to
Fault measurements.
Suffix:
<Chn>
Parameters:
<DtfSelectCable>
Example:
Options:
Manual operation:
CALCulate<Chn>:TRANsform:DTFault:STARt <Start>
CALCulate<Chn>:TRANsform:DTFault:STOP <Stop>
Defines the window of the Distance to Fault measurement using its start and stop dis-
tance.
See also
CALCulate<Chn>:TRANsform:DTFault:SPAN.
Suffix:
<Chn>
Parameters:
<Start>/<Stop>
Example:
Options:
Manual operation:
CALCulate<Chn>:TRANsform:DTFault:STATe <DtfState>
If channel <Chn> is performing an unsegmented frequency sweep, this command
allows to transform its active trace into a Distance to Fault (DtF) trace.
Suffix:
<Chn>
Parameters:
<DtfState>
Example:
User Manual 1173.9163.02 ─ 62
.
Channel number used to identify the active trace.
Name of the cable type.
CALCulate1:TRANsform:DTFault:SELect '5088-HFLR'
Selects cable type "5088-HFLR".
R&S ZNB/ZNBT-K3
See "Cable Type..."
CALCulate<Chn>:TRANsform:DTFault:CENTer
.
Channel number used to identify the active trace
Start/stop distance.
Default unit: m
:CALCulate1:TRANsform:DTFault:STARt 1; STOP 3
Defines the DtF distance window of the active trace of channel 1
as [1m, 3m].
R&S ZNB/ZNBT-K3
See "Start Distance / Stop Distance"
.
Channel number used to identify the active trace
OFF|ON – DtF disabled|enabled
*RST:
:CALCulate1:TRANsform:DTFault:STATE ON
turns the DtF representation of the active trace of channel 1 ON.
on page 730
OFF
Command reference
SCPI command reference
and
on page 729
999