R&S ZNB Series User Manual page 48

®
R&S ZNB/ZNBT
Table 3-2: Rear panel connectors available on all instruments
Index
1
2
3
4
5
6
7
8
9
10
11
12
User Manual 1173.9163.02 ─ 62
Label Description
(Power Power on / off switch, see
I/O) on page 28
LAN RJ-45 connector to integrate the instrument to a Local Area Network, primarily for
remote control purposes; see
on page 35.
See also Chapter 12.3.2, "LAN
USB / Two additional type A USB 3.0 host connectors; similar functionality as the USB con-
USB Host nectors on the front panel (see
Monitor External monitor connector (DisplayPort); see
(Display- tor", on page 32.
Port)
USB Type B USB 3.0 device (slave) connector for remote control of the instrument (see
Device Chapter 3.1.11.6, "Connecting a USB cable for remote
Monitor External monitor connector
●
DVI-D for 1st generation R&S ZNB
(DVI-D) /
●
HDMI for 2nd generation R&S ZNB
HDMI
See Chapter 3.1.11.1, "Connecting a
USER 25-pin D-Sub connector used as an input and output for low-voltage (3.3 V) TTL
PORT
control signals
See Chapter 12.3.1.1, "User
EXT TRIG Two BNC connectors for 5 V TTL external trigger signals
IN / EXT
See Chapter 5.10.3, "Trigger
TRIG
OUT
REF OUT BNC output for the internal reference frequency of the R&S ZNB. Use this connector
to synchronize other instruments to the analyzer.
REF IN BNC input for an external reference frequency. Use this connector to synchronize
the R&S ZNB to another device.
See Chapter 5.18.2, "Freq. Ref.
(System Contains the removable system drive of the R&S ZNB, containing all software
drive)
(including the operating system and the VNA application) and data. Do not remove
the system drive during operation.
Option R&S ZNB-B19 provides an additional removable system drive (including
operating system and firmware). See
drive", on page 258.
(Ground The ground connector provides the ground of the analyzer's supply voltage. Use this
connector) connector for ESD protection; see
on page 27.
Chapter 3.1.7, "Switching the instrument on and
Chapter 3.1.12.1, "Assigning an IP
interface", on page 1540.
"USB connectors" on page 44).
Chapter 3.1.11.1, "Connecting a moni-
monitor", on page 32.
Port", on page 1538.
tab", on page 437.
tab", on page 776.
Chapter 4.7.20, "Additional removable system
"Preventing electrostatic discharge (ESD)"
Getting started
Instrument tour
off",
address",
control", on page 34)
48