Table of Contents
Advertisement
®
R&S
ZNB/ZNBT
CALCulate:CALValidate:CHARacteriza <String>
Selects the CalU characterization to be used for the cal validation.
Use
for the validation.
Parameters:
<String>
Manual operation:
CALCulate:CALValidate:RESPonse:MAGNitude:LOWer <Port>, <Value>
CALCulate:CALValidate:RESPonse:MAGNitude:UPPer <Port>, <Value>
Defines the maximum magnitude deviations from the reference characterization S-
parameters that are allowed during cal validation.
Use
zation.
Parameters:
<Port>
<Value>
Manual operation:
CALCulate:CALValidate:RESPonse:PHASe:LOWer <Port>, <Value>
CALCulate:CALValidate:RESPonse:PHASe:UPPer <Port>, <Value>
Defines the maximum phase deviations from the reference characterization S-parame-
ters that are allowed during cal validation.
Use
zation.
Parameters:
<Port>
<Value>
Manual operation:
CALCulate:CALValidate:RUN
Runs the cal validation with its configured settings.
Usage:
Manual operation:
User Manual 1173.9163.02 ─ 62
CALCulate:CALValidate:STANdard
*RST:
See
CALCulate:CALValidate:CHARacteriza
Physical analyzer port no.
*RST:
Default unit: dB
See
CALCulate:CALValidate:CHARacteriza
*RST:
Default unit: degrees
See
Event
See
to select the CalU standard to be used
'Factory'
"Characterization"
on page 510
-0.2 (LOWer) | +0.2 (UPPer)
"Validation Limits"
on page 510
-2 (LOWer) | +2 (UPPer)
"Validation Limits"
on page 510
"Validate"
on page 509
Command reference
SCPI command reference
to select the reference characteri-
to select the reference characteri-
845
Advertisement
Chapters
Table of Contents
