R&S ZNB Series User Manual page 619

®
R&S ZNB/ZNBT
Evaluation Range...
The "Evaluation Range..." button opens the
restrict the frequency range of auto length (and loss) calculations.
5.13.2.2 Fixture Compensation dialog
This dialog allows you to correct the measurement result for the effects of a test fixture.
Access:
●
Channel – [Offset Embed] > "Offset" > "Fixture Compensation..."
●
Channel – [Offset Embed] > "One Way Loss" > "Fixture Compensation..."
Background Information
Refer to
Figure 5-55: Fixture Compensation dialog (for >4 ports)
Ports
Selects the ports for whom fixture compensation data shall be acquired.
Auto Length / Auto Length and Loss
"Auto Length" or "Auto Length and Loss" implies that a global electrical length offset
and loss is determined in analogy to the general offset compensation (see
ter 4.6.1.3, "Auto
on page 205).
Remote command:
[SENSe:]CORRection:COLLect:FIXTure:LMParameter:LOSS[:STATe]
User Manual 1173.9163.02 ─ 62
Chapter 4.6.1.5, "Fixture
Length", on page 204 and
Evaluation Range dialog
Compensation", on page 206.
Chapter 4.6.1.4, "Auto Length and
GUI reference
Offset Embed softtool
that allows you to
Chap-
Loss",
619