R&S ZNB Series User Manual page 416

®
R&S ZNB/ZNBT
5.8.2.1 Controls on the Power tab
left = R&S ZNB with
right = R&S ZNB/ZNBT with
If the number of test ports (on the VNA and connected switch matrices) is higher than
4, the "Step Attenuators" input fields are hidden. They are replaced by a "Step Attenua-
tors..." button that opens the following dialog:
Power
Determines the output power at the test ports for the sweep types "Lin Freq", "Log
Freq", "CW Mode", and "Time". Also determines the default output power for "Segmen-
ted" sweeps, where the output power can be set per segment.
The setting has no effect for
continuous range.
Remote command:
SOURce<Ch>:POWer<PhyPt>[:LEVel][:IMMediate][:AMPLitude]
User Manual 1173.9163.02 ─ 62
Receiver step attenuators
Receiver step attenuators
switch matrices
and 4 physical ports
and > 4 physical ports on the VNA and connected
Power sweeps, where the source power is varied over a
GUI reference
Stimulus softtool
416