R&S ZNB Series User Manual page 495

®
R&S ZNB/ZNBT
Characterization
See
Temperature Compensation
Available for inline calibration systems (ICS) only. Applies to all inline calibration units
(ICUs) that are connected to the ICS and that are used with factory characterization
data.
If checked, the R&S ZNB/ZNBT firmware adjusts the factory characterization data
according to the ICU temperatures.
Remote command:
[SENSe<Ch>:]CORRection:COLLect:AUTO:TEMPcomp
Calibration Type
Selects the calibration type for the selected physical ports. For an overview, refer to
Chapter 4.5.7.2, "Calibration
PTOSM are compatible with all port combinations.
Remote command:
[SENSe<Ch>:]CORRection:COLLect:AUTO:TYPE
[SENSe<Ch>:]CORRection:COLLect:AUTO:PORTs:TYPE
[SENSe<Ch>:]CORRection:COLLect:AUTO:CONFigure
Power Meter
Shows a list of all power meters that have been properly configured and are available
for the scalar source power calibration of a single source port. The last configured
power meter is selected by default. See
Remote command:
[SENSe:]CORRection:COLLect:PMETer:ID
Power Port
Selects the port for the scalar source power calibration.
Select All/Deselect All
Selects/deselects all ports.
These buttons are only shown if more than 4 ports are available.
Step 2: Connections
Defines the port assignments between the R&S ZNB/ZNBT and the calibration unit.
Related information
Refer to
ple port assignments.
The layout of the main panel depends on the number of test ports available.
User Manual 1173.9163.02 ─ 62
"Characterization" on page 451.
Chapter 4.5.5.6, "Multiple port
types", on page 200. The calibration types PUOSM and
"Configured Devices"
assignments",
GUI reference
Cal softtool
on page 782.
on page 191 for details on multi-
495