R&S ZNB Series User Manual page 752

®
R&S ZNB/ZNBT
● Presets
● Calibration
● User Interface
● Messages
● Channel Bits
● Advanced
● Power
● Recovery
● HUMS
Presets tab
Specifies the behavior of the R&S ZNB/ZNBT upon a preset.
Preset Scope
Defines whether a preset affects all open recall sets ("Instrument") or the active recall
set only.
The "Preset Scope" applies to the GUI and to the
mand. The *RST command always resets all open recall sets.
Remote command:
SYSTem:PRESet:SCOPe
Remote Preset Configuration
"Align *RST to User Defined Preset" defines the behavior of the *RST and
SYSTem:PRESet commands. If checked, and if a valid setup file is selected in the
set Configuration
perform a factory preset.
Remote command:
SYSTem:PRESet:REMote[:STATe]
Global Settings
The two buttons reset all directory settings (e.g. the directories for storing trace data,
limit lines, calibration data...) and all settings in the "Printer Setup" dialog to default val-
ues. See
Remote command:
n/a
User Manual 1173.9163.02 ─ 62
tab............................................................................................................ 752
tab....................................................................................................... 753
tab..................................................................................................755
tab........................................................................................................757
tab....................................................................................................758
tab........................................................................................................ 759
tab..............................................................................................................761
tab......................................................................................................... 763
tab..............................................................................................................763
section, then they perform a user-defined preset. Otherwise, they
Chapter 5.14.4, "Printer Setup
SYSTem:PRESet[:DUMMy]
dialog", on page 675.
GUI reference
Setup softtool
com-
Pre-
752