R&S ZNB Series User Manual page 595

®
R&S ZNB/ZNBT
Background information
Refer to the following sections:
●
Chapter 4.7.4.2, "Scalar mixer
●
"Two-stage mixer measurements"
5.12.6.1 Controls on the Mixer Mode tab
Most of the "Mixer Mode" buttons are only enabled if the mixer measurement is set up
properly. They open wizards or dialogs:
●
"Mixer Meas Wizard...": See
on page 595
●
"Mixer Setup...": See
●
"SMARTerCal" – "Start... (Cal Unit)": see
Unit) wizard for mixer
●
"SMARTerCal" – "Start... (Manual)": see
ual) wizard for mixer
●
"SMARTerCal" – "Repeat...": launches the adequate "Mixer Meas"-specific wiz-
ard to repeat the currently active "SMARTerCal" (if available)
Reset Freq Conv
"Reset Freq Conv" disables all frequency conversion measurements in the active
channel, including intermodulation measurements.
A "Mix" label in the channel list indicates that a mixer measurement is active.
Remote command:
[SENSe<Ch>:]FREQuency:CONVersion
5.12.6.2 Mixer Presetting wizard
The "Mixer Presetting" wizard guides you through the setup of a mixer measurement.
User Manual 1173.9163.02 ─ 62
measurements",
on page 239
Chapter 5.12.6.2, "Mixer Presetting
Chapter 5.12.6.3, "(Mixer) Setup
mode", on page 602
Chapter 5.12.6.5, "SMARTerCal (Man-
mode", on page 603
Channel Config softtool
on page 238
dialog", on page 598
Chapter 5.12.6.4, "SMARTerCal (Cal
GUI reference
wizard",
595