R&S ZNB Series User Manual page 479

®
R&S ZNB/ZNBT
SOURce<Ch>:POWer:CORRection:DATA:PORT<PhyPt>
[SENSe<Chn>:]CORRection:PSTate?
Power Cal dialog – Ref. Receiver
In Ref. Receiver mode, the "Power Cal" dialog guides you through a reference receiver
calibration.
The selected source port is displayed with its cal power settings (see
"Modify Cal Power
A power meter must be connected to the calibrated source port.
Access:
Background information
Refer to
Start Cal Sweep
Starts the calibration sweeps for the selected port and power calibration settings and
closes the dialog. The calibration is performed as described in
on page 195.
Open the
Remote command:
SOURce<Ch>:POWer:CORRection[:ACQuire]
SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect[:ACQuire]
User Manual 1173.9163.02 ─ 62
dialog", on page 527). A circuit diagram visualizes the connectivity.
Power Cal wizard > Ref. Receiver
Chapter 4.5.6.1, "Source power
Pwr Cal Settings tab
calibration", on page 195.
if you wish to modify the calibration procedure.
GUI reference
Cal softtool
Chapter 5.11.3.2,
"Calibration procedure"
479