R&S ZNB Series User Manual page 360

®
R&S ZNB/ZNBT
Remote command:
CALCulate<Chn>:STATistics:NLINear:COMP:RDOMain:USER
CALCulate<Chn>:STATistics:NLINear:COMP:RDOMain:USER:STARt
CALCulate<Chn>:STATistics:NLINear:COMP:RDOMain:USER:STOP
CALCulate<Chn>:STATistics:NLINear:COMP:RDOMain:USER:SHOW
Defined Value
This setting is only visible if "Defined Value" is used as
defines the reference value ("small signal value") for the compression point calculation.
Remote command:
CALCulate<Chn>:STATistics:NLINear:COMP:RLEVel
CALCulate<Chn>:STATistics:NLINear:COMP:RPHase
5.5.8.2 Evaluation Range dialog
The "Evaluation Range" dialog defines the range for various trace evaluation opera-
tions (trace statistics, offset, loss and fixture compensation calculations). The evalua-
tion range is a continuous interval of the sweep variable.
Access:
●
Trace – [Trace Config] > "Trace Statistics" > "Evaluation Range..."
●
Channel – [Offset Embed] > "Offset" > "Evaluation Range..."
●
...
Evaluation Range
Selects a predefined evaluation range. Up to 10 different ranges are available for each
recall set. "Full Span" means that the search range is equal to the entire sweep range.
The trace statistics functions consider all measurement points with stimulus values x
between the "Start" and "Stop" value of the evaluation range:
"Start" ≦ x
The evaluation ranges are defined similar to the marker search ranges. For more infor-
mation, see
Note: A restricted evaluation range is indicated in the "Trace Statistics" info field.
User Manual 1173.9163.02 ─ 62
≦ "Stop"
i
Chapter 5.7.3.2, "Search Range
Trace Config softtool
Reference Value. It manually
dialog", on page 399.
GUI reference
i
360