R&S ZNB Series User Manual page 855

®
R&S ZNB/ZNBT
CALCulate:DATA:TRACe <TraceName>, <Format>, <Data>...
The query gets the trace data of an arbitrary (not necessarily the active) trace, refer-
enced by its trace name <TraceName>.
The "set direction" allows to import formatted or unformatted trace data to an existing
trace (data access point 3 or 2 in
Note
●
Unformatted trace data (SDATa) can only be imported to memory traces
●
Formatted trace data (FDATa) can only be imported to "live" traces if the related
channel is in single sweep mode
Before the import, the target trace must be prepared according to the settings used
during export. Any request for new data from the hardware ("Restart Sweep" in sin-
gle sweep mode or switching to continuous sweep mode) discards imported data
and switches back the display to measured data.
Parameters:
<TraceName>
<Format>
<Data>
Example:
7.3.1.3 CALCulate:DTIMe...
Defines the properties and retrieves the results of the skew measurement provided
with the
CALCulate<Chn>:DTIMe:DATA?
CALCulate<Chn>:DTIMe:LIMit:FAIL?
CALCulate<Chn>:DTIMe:LIMit:FAIL:BEEP
CALCulate<Chn>:DTIMe:LIMit:LIMit
CALCulate<Chn>:DTIMe:LIMit:STATe
CALCulate<Chn>:DTIMe:POSition
CALCulate<Chn>:DTIMe:STATe
CALCulate<Chn>:DTIMe:TARGet
CALCulate<Chn>:DTIMe:DATA? [<Data>]
Queries the results of the skew measurement
Suffix:
<Chn>
User Manual 1173.9163.02 ─ 62
String parameter containing the trace name
FDATa | SDATa | MDATa | NCData | UCData
Data format; see
Trace data for FDATa | SDATa import either in ASCII or block
data format, depending on the current
The column order must match the one used during export.
See CALCulate<Chn>:DATA.
Extended time domain analysis
..................................................................................... 855
...................................................................................... 857
....................................................................................858
.
Channel number used to identify the active trace
Chapter 4.1.5, "Data
(INITiate<Ch>:CONTinuous
Table 7-2.
option R&S ZNB/ZNBT-K20.
............................................................................... 856
....................................................................... 856
................................................................................ 857
.............................................................................. 857
...................................................................................857
Command reference
SCPI command reference
flow", on page 98).
OFF).
FORMat[:DATA]
setting.
855