R&S ZNB Series User Manual page 991

®
R&S ZNB/ZNBT
Manual operation:
CALCulate<Chn>:STATistics:NLINear:COMP:RMARker <Marker>
Allows you to select the marker whose value shall be used as the reference ("small sig-
nal value") for the compression point calculation.
Only applies if
to MARKer.
Suffix:
<Chn>
Parameters:
<Marker>
Manual operation:
CALCulate<Chn>:STATistics:NLINear:COMP:RPHase <Phase>
Manually defines the reference phase for compression point calculation on phase for-
matted traces.
Only applies if
to DVALue.
For dB formatted traces, the reference level can be set using
STATistics:NLINear:COMP:RLEVel.
Suffix:
<Chn>
Parameters:
<Phase>
Manual operation:
CALCulate<Chn>:STATistics:NLINear:COMP[:STATe] <Boolean>
Displays or hides the compression point result in the diagram area channel <Chn>'s
active trace..
Suffix:
<Chn>
Parameters:
<Boolean>
User Manual 1173.9163.02 ─ 62
See "Defined Value"
CALCulate<Chn>:STATistics:NLINear:COMP:REFerence
.
Channel number used to identify the active trace
Marker number
If marker <Marker> is OFF for the related trace, the set com-
mand is silently ignored.
See "Selected Marker"
CALCulate<Chn>:STATistics:NLINear:COMP:REFerence
.
Channel number used to identify the active trace
Reference phase
*RST: 1°
Default unit: deg
See "Defined Value"
.
Channel number used to identify the active trace
ON | OFF - statistical info field on or off.
*RST: OFF
Command reference
SCPI command reference
on page 360
on page 359
CALCulate<Chn>:
on page 360
is set
is set
991