R&S ZNB Series User Manual page 308

®
R&S ZNB/ZNBT
5.2.7 Y-Z-Params tab
Allows you to select Y- and Z-parameters as measured quantities. Both Y- and Z-
parameters can serve as an alternative to S-parameters for characterizing a linear n-
port network.
Background information
Refer to the following sections:
●
Chapter 4.3.3, "Impedance
●
Chapter 4.3.4, "Admittance
●
Chapter 4.3.3.2,
●
Chapter 4.3.4.2,
Y/Z-Parameter
Selects an
For an n-port vector network analyzer, the pull-down list provides the full set of n
and Z-parameters.
Y- and Z-parameters are expressed as Y/Z
output and input port numbers of the DUT.
Remote command:
CALCulate<Ch>:PARameter:MEASure
"Z11" ...
CALCulate<Ch>:PARameter:SDEFine
"Z11" ...
Y11/Y12 /Y21/Y22
Selects one of the 2-port
quantity for the active trace. The Y-parameters describe the admittances of a DUT with
output ports terminated in a short circuit (V = 0).
User Manual 1173.9163.02 ─ 62
parameters",
parameters",
"Z-parameters",
"Y-parameters",
Y-parameter or Z-parameter
Chapter 4.3.4.2,
on page 130
on page 134
on page 133
on page 134
as a measured quantity for the active trace.
, where <out> and <in> denote the
<out>< in>
"<Trace_Name>", "Y11" |
"<Trace_Name>", "Y11" |
"Y-parameters", on page 134 as a measured
GUI reference
Meas softtool
2
Y-
308