R&S ZNB Series User Manual page 915

®
R&S ZNB/ZNBT
CALCulate:FMODel:ISD:PRESet
Restores the global default settings of the ISD tool.
Usage:
Manual operation:
CALCulate:FMODel:ISD:RUN:RUN
Runs the ISD tool.
Before executing this command, make sure that
●
the test coupon measurement (using
MEASure:OPEN
1xOpen+1xShort,
ished successfully, or the test coupon data were successfully loaded from file
(using
●
the measurement of DUT + test fixture (using
MEASure) finished successfully
The resulting Touchstone files are written to C:\Users\Public\Documents\Rohde-
Schwarz\Vna\Embedding. If result files with the same name already exist, they will be
overwritten.
Example:
Usage:
Manual operation:
CALCulate:FMODel:ISD<Pt>:RUN[:STATe] <Boolean>
For a fixture modeling with the ISD tool, this command allows to specify the ports to
which the deembedding files shall be assigned after the tool has run.
Suffix:
<Pt>
Parameters:
<Boolean>
Example:
Manual operation:
CALCulate:FMODel:ISD:SCALe:ATTenuation <AttenLeadInScaling>
Scales the test coupon's attenuation (dB).
Sets/gets the atten_scale 1 batch mode parameter of the ISD tool
User Manual 1173.9163.02 ─ 62
Event
See "Reset to Default"
and
CALCulate:FMODel:ISD:COUPon:MEASure:SHORt
CALCulate:FMODel:ISD:COUPon:MEASure
CALCulate:FMODel:ISD:COUPon:MEASure:FILename
See Chapter 8.2.8, "Fixture
Event
See "Run <Fixture Modeling Tool>"
.
Physical port number for single-ended deembedding, logical port
number for balanced deembedding.
1 (ON) if a deembedding file shall be assinged to port <Pt>, 0
(OFF) otherwise
See Chapter 8.2.8, "Fixture
See "Apply"
on page 629
CALCulate:FMODel:ISD:COUPon:
CALCulate:FMODel:ISD:DUT:
modeling",
modeling",
on page 634
Command reference
SCPI command reference
otherwise) fin-
on page 1527
on page 633
on page 1527
for
915