R&S ZNB Series User Manual page 317

®
R&S ZNB/ZNBT
Remote command:
[SENSe<Ch>:]PAE:TYPE
Formula
Shows the formula for the calculation of the DC supply power P
selected
accordance with the properties with the DC power source and precision resistor in use.
Remote command:
[SENSe<Ch>:]PAE:PARameters:I
[SENSe<Ch>:]PAE:PARameters:R
[SENSe<Ch>:]PAE:PARameters:U
In/Out
Define the logical ports for the RF input and output signal, respectively.
Remote command:
CALCulate<Ch>:PARameter:MEASure
CALCulate<Ch>:PARameter:SDEFine
U /U
m
Select the DC Input connectors used to determine the DC supply power.
How many of them are required depends on the selected
Remote command:
[SENSe<Ch>:]PAE:DCINput:MAIN
[SENSe<Ch>:]PAE:DCINput:SECondary
Range DC
Select the DC range of each DC Input connector in use according to the (estimated)
input voltage range; see
Remote command:
[SENSe<Ch>:]DC<DCInp>:RANGe
5.2.12 External DLL tab
The "External DLL" tab allows you to add/remove custom plug-ins to/from the firmware.
It gives access to their configuration, tasks, and traces.
Background information
Refer to
User Manual 1173.9163.02 ─ 62
Measurement Type. The parameters R, U
/U /
m1 m2
"DC 1/DC 2/DC 3/DC 4/Source Port"
Chapter 4.7.30, "External
, and/or I
0
'TraceName', 'PAE21 | ...'
'TraceName', 'PAE21 | ...'
DLLs", on page 276.
GUI reference
Meas softtool
, depending on the
DC
must be entered in
0
Measurement Type.
on page 315.
317