R&S ZNB Series User Manual page 570

®
R&S ZNB/ZNBT
Figure 5-46: Stimulus Dialog: Power Sweep
Except for the "Enter & Display" properties, all these parameters can also be set in the
Sweep
can be modified.
Table 5-3: Parameters for frequency sweeps
Enter & Display
Start
Stop
Power
Number of Sweep
Points
Enter & Display
The "Enter & Display" combo boxes in the "Frequency Sweep" and "Power Sweep"
sections of the "Stimulus" dialog control how frequency and power values are entered
and displayed in this dialog.
You can either take the channel perspective (f
source or receiver. The two can be used interchangeably to define the sweep, if the
user-defined linear transformation relating them is not constant.
Note: For frequency sweeps, source/receiver-specific linear frequency transformation
are enabled with option R&S ZNB/ZNBT-K4 (see
sion
5.12.2.3 Define Parallel Measurement dialog
With the R&S ZNBT or a 4-port R&S ZNB with internal second source, you can mea-
sure multiple DUTs (or multiple paths of a single DUT) in parallel. The "Define Parallel
Measurement" dialog allows you to configure these DUTs and to declare the connec-
tions between physical VNA ports and DUT ports. Furthermore it provides convenient
access to port-related settings.
User Manual 1173.9163.02 ─ 62
Softtool. Depending on the channel's
Lin/Log Freq Sweep
x
x
x
x
x
measurements", on page 236).
Channel Config softtool
Sweep Type, a different set of parameters
CW Mode Sweep Time Sweep
x x
– –
– –
x x
x x
, P ), or the perspective of a particular
b b
Chapter 4.7.4, "Frequency conver-
GUI reference
570