R&S ZNB Series User Manual page 988

®
R&S ZNB/ZNBT
Use
compression results.
Suffix:
<Chn>
Parameters:
dBValue
Example:
Manual operation:
CALCulate<Chn>:STATistics:NLINear:COMP:PHASe <PhaseValue>
Defines the compression value x for the compression point measurement for phase
formatted traces.
Use
compression results.
Suffix:
<Chn>
Parameters:
<PhaseValue>
Manual operation:
CALCulate<Chn>:STATistics:NLINear:COMP:RDOMain:USER <RefRange>
Selects one of the 10 channel-specific user defined ranges as the reference range for
compression point calculation.
Only applies if
to RANGe.
The selected range can then be configured with the
STATistics:NLINear:COMP:RDOMain:USER:STARt,
STATistics:NLINear:COMP:RDOMain:USER:STOP, and
STATistics:NLINear:COMP:RDOMain:USER:SHOW
Suffix:
<Chn>
Parameters:
<RefRange>
Manual operation:
User Manual 1173.9163.02 ─ 62
CALCulate<Chn>:STATistics:NLINear:COMP:RESult?
.
Channel number used to identify the active trace
Compression value
See
RESult?
See
CALCulate<Chn>:STATistics:NLINear:COMP:RESult?
.
Channel number used to identify the active trace
Compression value
Default unit: deg
See
CALCulate<Chn>:STATistics:NLINear:COMP:REFerence
.
Channel number used to identify the active trace
Range number
Range:
*RST:
See
CALCulate<Chn>:STATistics:NLINear:COMP:
"Compr. Point / Compr. Val."
"Compr. Point / Compr. Val."
1 to 10. In addition, 0 denotes the (non-configura-
ble) "Full Span" evaluation range.
0
"Ref. Range" on page 359
Command reference
SCPI command reference
to retrieve the
on page 358
to retrieve the
on page 358
CALCulate<Chn>:
CALCulate<Chn>:
CALCulate<Chn>:
commands.
is set
988