Table of Contents
Advertisement
®
R&S
ZNB/ZNBT
CALCulate:CALValidate:STANdard <Standard>
Selects the CalU standard to be used for cal validation.
Parameters:
<Standard>
7.3.1.2
CALCulate:DATA...
The CALCulate:DATA... commands provide access to the results of a measure-
ment.
Data format
The trace data is transferred in either ASCII or block data (REAL) format, depending
on the
select EOI as a receive terminator
RTERminator
CALCulate:DATA:TRACe
CALCulate<Chn>:DATA <Format>, <Data>...
CALCulate<Chn>:DATA? <Format>
The query reads the response values of the selected channel's active trace or reads
error terms of the selected channel.
The "set command" either imports formatted or unformatted trace data to the selected
channel's active trace (see
terms of the selected channel.
Note
●
The data format is parameter-dependent; see tables below. The unit is the default
unit of the measured parameter; see CALCulate<Ch>:PARameter:SDEFine.
●
Unformatted trace data (SDATa) can only be imported to memory traces
●
Formatted trace data (FDATa) can only be imported to "live" traces if the related
channel is in single sweep mode
User Manual 1173.9163.02 ─ 62
OPEN | SHORt | MATCh
setting. If block data format is used, it is recommended to
FORMat[:DATA]
EOI).
..................................................................................................846
................................................................................................... 849
...........................................................................................850
.................................................................................................852
................................................................................................ 855
Chapter 4.1.5, "Data
(SYSTem:COMMunicate:GPIB[:SELF]:
............................................................................851
.............................................................................851
.......................................................................... 851
.......................................................................852
.......................................................................852
......................................................................... 852
....................................................................... 853
.................................................................................... 854
................................................................................. 854
flow",
(INITiate<Ch>:CONTinuous
Command reference
SCPI command reference
on page 98) or writes error
OFF).
846
Advertisement
Chapters
Table of Contents
