R&S ZNB Series User Manual page 764

®
R&S ZNB/ZNBT
Common controls
State (Device Utilization)/Status
Enables/disables the HUMS service.
The "Status" LED indicates the current state of the HUMS service:
●
grey: inactive
●
green: up and runnning
If HUMS has been used before, turning on restores the previous
Remote command:
DIAGnostic:HUMS:STATe
REST ← State (Device Utilization)/Status
Enables/disables the
Remote command:
SYSTem:COMMunicate:REST:ENABle
SNMP ← State (Device Utilization)/Status
Enables/disables the
supported SNMP protocol versions.
Depending on the enabled versions, different parts of the
Note: If you activate v2c, version v1 is also active.
Remote command:
SYSTem:COMMunicate:SNMP:VERSion
Delete HUMS History
Allows you to delete the previousy collected health and monitoring information from the
instrument.
Remote command:
DIAGnostic:HUMS:DELete:ALL
Export HUMS History
Allows you to export the previousy collected health and monitoring information to a zip-
ped JSON file.
Remote command:
DIAGnostic:HUMS:DELete:ALL
Protocol subtab
Gives access to SNMP configuration options for protocol version 2c and 3.
SNMPv2c Configuration
Allows you to grant read or read-write access via SNMPv2c, and to specify the related
community string.
User Manual 1173.9163.02 ─ 62
REST interface to the HUMS service.
SNMP interface to the HUMS service and allwos you to select the
GUI reference
Setup softtool
protocol settings.
Protocol subtab are enabled.
764