R&S ZNB Series User Manual page 756

®
R&S ZNB/ZNBT
Show Sweep Symbols
This checkbox turns sweep symbols on or off.
Sweep symbols are arrows pointing downward onto the trace. They are displayed if the
sweep time exceeds an upper limit, e.g. if the number of points is high or the measure-
ment bandwidth is low.
Remote command:
n.a.
Use Default Tab for Hardkey
If the checkbox is selected (system default), the
enabled tab of their associated softtool. Otherwise the last used tab is activated.
For background information, see
on page 282.
Remote command:
n/a
Conductance in Embedding Networks
Changes the presentation of "capacitance C<i> in parallel with resistance R<i>" circuit
blocks in lumped de/embedding networks (see
port
on page 212).
If active, the resistance R<i> is displayed and specified as conductance G<i> (=1/
R<i>).
Remote command:
SYSTem:DISPlay:CONDuctancesn/a
Restart: Set all Traces to 0
Defines the behavior of the "Restart Sweep" function (see
on page 443).
If unchecked (factory default) the previous measurement data are preserved. If
checked, they are deleted.
Remote command:
SYSTem:TRESet[:STATe]
Show X-Axis Grid Labels
If enabled, the firmware displays X-axis grid labels in cartesian diagrams with linear
scale.
Remote command:
SYSTem:DISPlay:XLABels
Number of Trace Colors
Defines the maximum number of trace colors (trace properties for the
color
User Manual 1173.9163.02 ─ 62
networks", on page 210 and
scheme).
Function keys
Chapter 5.1, "Function Keys and
Chapter 4.6.2.3, "Circuit models for 2-
Chapter 4.6.2.4, "Circuit models for 4-port
GUI reference
Setup softtool
activate the first
Softtools",
networks",
"Restart Sweep"
user defined
756