R&S ZNB Series User Manual page 446

®
R&S ZNB/ZNBT
5.11.1 Start Cal tab
The "Start Cal" tab provides access to all functions for automatic or manual calibration.
Calibration of the R&S ZNB/ZNBT is a fully guided process.
Background information
Refer to the following sections:
●
Chapter 4.5,
●
Chapter 4.5.5, "Automatic
●
Chapter 4.5.6, "Scalar power
●
Chapter 4.5.7,
●
Chapter 4.1.5, "Data
It is possible to set up, perform and activate multiple system error corrections or
SMARTerCals in a single calibration procedure. However, this
tion Wizard
tab of the "System Config" dialog.
5.11.1.1 Controls on the Start Cal tab
●
The "Start Auto Cal" and "Start... (Cal Unit)" buttons are only active if a calibration
unit is connected to the analyzer.
●
If there is more than one channel in the current recall set at the time you initiate a
calibration, the
User Manual 1173.9163.02 ─ 62
"Calibration", on page 162
calibration",
calibration",
"SMARTerCal",
flow", on page 98
feature is disabled by default and has to be activated in the "Calibration"
Channel Selection for Calibration dialog
on page 181
on page 193
on page 199
GUI reference
Cal softtool
Multiple Cal in Calibra-
is opened.
446