Resume Hardware-Group - Avaya S8700 Maintenance Manual

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance Commands

resume hardware-group

In the course of execution of a test hardware-group command, it may be

desirable to halt the test temporarily or permanently. This is accomplished by

either the cancel hardware-group command for a background test, or by

restart the hardware group test at the point where it was canceled. This capability

is not available if another hardware group test has been started. The status of a

hardware group test can be obtained with status hardware-group .

When test hardware-group all-ports is canceled, the internally generated port

translations for previously untranslated ports are removed. If resume

hardware-group is then entered, only customer-administered ports will then be

tested. resume does not reinstate the port translations that were removed by

cancellation of the test.

When a test that was executing in the background is resumed, a success

message is displayed. When a test that was executing in the foreground is

resumed, test results are displayed.

Issue 1 May 2002

for a foreground test. Resume hardware-group enables you to