Ip Redirect-Group - Dell S6000 Reference Manual

Related ip redirect-list
Commands

ip redirect-group

Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an
interface by entering this command multiple times.
S6000
Syntax
ip redirect-group redirect-list-name
To remove a redirect list from an interface, use the no ip redirect-group
name command.
Parameters
redirect-list-
name
Defaults none
Command INTERFACE (conf-if-vl-)
Modes
Command
Version 9.4.0.0
History
Version 8.4.2.1
Version 8.4.2.0
Version 7.4.2.0
pre-Version
7.7.1.0
Usage
You can apply any number of redirect-groups to an interface. A redirect list can
Information
contain any number of configured rules. These rules includes the next-hop IP
address where the incoming traffic is to be redirected.
If the next hop address is reachable, traffic is forwarded to the specified next hop.
Otherwise, the normal routing table is used to forward traffic. When a redirect-
group is applied to an interface and the next-hop is reachable, the rules are added
into the PBR CAM region. When incoming traffic hits an entry in the CAM, the
traffic is redirected to the corresponding next-hop IP address specified in the rule.
Related
•
Commands
Policy-based Routing (PBR)
– enables an IP Redirect List.
Enter the name of a configured redirect list.
Introduced on the S6000.
Introduced on the C-Series and S-Series.
Introduced on the E-Series TeraScale.
Added support for LAG and VLAN interfaces.
Introduced on the E-Series ExaScale.
NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.
show cam pbr – displays the content of the PBR CAM.
1047