Ip Ospf Hello-Interval - Allied Telesis x310-26FT Command Reference Manual

OSPF C
OMMANDS
-
IP OSPF HELLO INTERVAL

ip ospf hello-interval

Overview This command specifies the interval between hello packets.
The hello-interval is advertised in the hello packets. Configure the same
hello-interval for all routers on a specific network. A shorter hello interval ensures
faster detection of topological changes, but results in more routing traffic.
The no variant of this command returns the interval to the default of 10 seconds.
ip ospf [<ip-address>] hello-interval <1-65535>
Syntax
no ip ospf [<ip-address>] hello-interval
Default The default interval is 10 seconds.
Mode Interface Configuration for a VLAN interface.
Example The following example shows setting the hello-interval to 3 seconds on VLAN
interface vlan2.
awplus#
awplus(config)#
awplus(config-if)#
Related ip ospf dead-interval
Commands
show ip ospf interface
C613-50103-01 REV A
Parameter Description
<ip-address> The IP address of the interface, in dotted decimal notation.
<1-65535>
The interval in seconds.
Default: 10
configure terminal
interface vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ip ospf hello-interval 3
902