Avaya DEFINITY Server CSI Maintenance Manual page 703

ANN-BD (Announcement Circuit Pack)
Angel-Speech Processor (SP) Handshake Test
(#208)
This test checks the integrity of the communication link between the two
processors on the Announcement circuit pack.
!
WARNING:
Failure of this test indicates that the Speech Processor is insane and results
in the loss of all integrated announcements on the circuit pack.
Table 58. TEST #208 Angel-Speech Processor (SP) Handshake Test
Error Test
Code Result
2000 ABORT
2100 ABORT
ABORT
FAIL
PASS
555-233-119
Description/ Recommendation
Response to the test request was not received within the allowable time
period. If Error Type 1538 is present in the Error Log, follow the
maintenance strategy recommended for this Error Type.
Could not allocate the necessary system resources to run this test.
Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Test failed. Circuit pack cannot be used. Announcement speech memory
is cleared when this test fails. Therefore, when the problem has been
resolved, announcements must be rerecorded or downloaded to the
circuit pack.
1. Use reset board PCSS to reset the circuit pack and run the test again.
If the test continues to fail, replace the circuit pack and run the test
again.
2. If there are recurring alarms on this circuit pack caused by this test
failing, replace the circuit pack even if Step 1 works.
!
WARNING:
Replacing the circuit pack results in loss of integrated
announcements. See
Maintenance documentation.
The communications link between the two processors on the
Announcement circuit pack is functioning properly. User-reported troubles
on this circuit pack should be investigated using other circuit pack and port
tests. Refer to "ANN-PT (Announcement Port)" Maintenance
documentation for a description of the port tests.
''General Notes'' near the beginning of this
Continued on next page
Issue 5 October 2002
703