Avaya DEFINITY Server CSI Maintenance Manual page 680

Maintenance Objects
Table 50. TEST #6 NPE Crosstalk Test — Continued
Error Test
Code Result
1018 ABORT
2000 ABORT
2100 ABORT
Any FAIL
PASS
0 NO
BOARD
680
Issue 5 October 2002
Description/Recommendation
Test has been disabled via administration. The default for the
the Station screen is y. Determine why this field has been set to
station. It may be due to application Test #48, which can disturb users or
terminal operations.
1. To enable the test for the station being tested, enter change station
extension and set the
Response to the test request was not received within the allowable time
period.
System resources required to run test are not available. This could be due to
a failure to seize the port.
1. Retry the command at 1-minute intervals no more than 5 times.
2. If the test continues to abort, escalate the problem.
This test can fail due to on-board or off-board problems. Off-board problems
include TDM-BUS faults, EXP-PN and EXP-INTF faults, and faults
associated with the tone detectors/tone generators. Clear all off-board
problems before replacing the board.
1. A TDM-BUS problem is usually the result of a faulty board connection to
the backplane, or bent pins on the backplane. Resolve any TDM-BUS
errors in the error log.
2. Resolve any EXP-PN and/or EXP-INTF errors in the error log.
3. Resolve any TONE-BD and/or TONE-PT errors in the error log.
4. Test the board when the faults from Steps 1, 2, and 3 are cleared.
Replace the board if the test fails.
The port is correctly using its allocated time slots. Investigate user-reported
troubles on this port by running other port tests, by examining station wiring,
or by inspecting the station.
The test could not relate the internal ID to the port (no board). This result
could be due to incorrect translations, no board is inserted, an incorrect
board is inserted, or an insane board is inserted.
1. Check to make sure that the board translations are correct. Use list
configuration and resolve any problems.
2. If the board is correctly inserted, use busy board UUCSS.
3. Issue reset board UUCSS.
4. Issue release board UUCSS.
5. Issue test board UUCSS long. This re-establishes the link between the
internal ID and the port.
6. If this is not the case, check to make sure that a valid board is inserted.
Test field to y.
Test field on
n
for this
Continued on next page
555-233-119