Avaya DEFINITY Server CSI Maintenance Manual page 685

AN-LN-PT (Analog Line Port)
Table 52. TEST #35 Battery Feed Test — Continued
Error Test
Code Result
0 NO
BOARD
Station Status and Translation Audits and
Updates Test (#36)
This test updates the analog port's message lamp state (if it has one) and
translations with information in the software.
Table 53. Test #36 Station Status and Translation Audits and Updates
Error Test
Code Result
ABORT
1004 ABORT
1005 ABORT
555-233-119
Description/Recommendation
The test could not relate the internal ID to the port (no board). This result
could be due to incorrect translations, no board is inserted, an incorrect
board is inserted, or an insane board is inserted.
1. Check to make sure that the board translations are correct. Use list
configuration, and resolve any problems.
2. If the board is correctly inserted, use busy board UUCSS.
3. Issue reset board UUCSS.
4. Issue release board UUCSS.
5. Issue test board UUCSS long. This re-establishes the link between
the internal ID and the port.
6. If this is not the case, check to make sure that a valid board is inserted.
Description/ Recommendation
Necessary system resources could not be allocated to run this test.
1. Retry the command at 1-minute intervals no more than 5 times.
2. If the test continues to abort, escalate the problem.
A valid call seized the port during the test and aborted the test.
1. Use display port UUCSSpp to determine the station extension.
2. Use status station extension to determine the service state of the
port.
3. If the port is in use, wait until the port is idle before testing. Retry the
command at 1-minute intervals no more than 5 times.
4. If the test continues to abort, escalate the problem.
This test was aborted due to a configuration problem. The test is not
applicable for this type of analog port. This error can be ignored.
Continued on next page
Continued on next page
Issue 5 October 2002
685