Installation Locations For The Calibration Tools - ABB Robotics IRB 1100 Product Manual

6.4.3 Installation locations for the calibration tools

Location of fixed calibration items
This section shows how the robot is equipped with items for installation of
calibration tools for Axis Calibration (fixed calibration pins and/or bushings).
Installed calibration tools are not shown.
A fixed calibration pin and a bushing for the movable calibration tool are located
on each axis as follows.
If there is not enough space on an axis to install a fixed calibration pin, the axis is
equipped with two bushings instead, for installation of two calibration tools when
calibration is carried out. This is shown in the figure.
For axis 6 there is only one bushing, the second calibration tool is installed at the
mounting flange of the turning disk.
xx1800003320
Product manual - IRB 1100
3HAC064992-001 Revision: C
6.4.3 Installation locations for the calibration tools
© Copyright 20192020 ABB. All rights reserved.
6 Calibration
Continues on next page
575