ABB Robotics IRB 1100 Product Manual page 206

5 Repair
5.4.1 Replacing the base
Continued
Removing the brake release button
Notice that the procedure differs depending on if the connector interface is located
either at the rear or at the bottom of the base.
1
2
3
4
Continues on next page
206
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
Valid for cabling with rear interface
Remove the base bottom cover.
Valid for cabling with bottom interface (option
3309-1)
Remove the base rear cover.
Disconnect the earth cable.
© Copyright 20192020 ABB. All rights reserved.
Note
xx1800003035
xx1800003057
xx1800003036
Product manual - IRB 1100
3HAC064992-001 Revision: C