Calibrating With Axis Calibration Method; Description Of Axis Calibration - ABB Robotics IRB 1100 Product Manual

6.4 Calibrating with Axis Calibration method

6.4.1 Description of Axis Calibration

Instructions for Axis Calibration procedure given on the FlexPendant
The actual instructions of how to perform the calibration procedure and what to
do at each step is given on the FlexPendant. You will be guided through the
calibration procedure, step by step.
This manual contains a brief description of the method, additional information to
the information given on the FlexPendant, article number for the tools and images
of where to fit the calibration tools on the robot.
Overview of the Axis Calibration procedure
The Axis Calibration procedure applies to all axes, and is performed on one axis
at the time. The robot axes are both manually and automatically moved into position,
as instructed on the FlexPendant.
A fixed calibration pin/bushing is installed on each robot axis at delivery.
For axis 6 calibration there is one bushing on the wrist and one mounting hole on
the tool flange.
The Axis Calibration procedure described roughly:
Product manual - IRB 1100
3HAC064992-001 Revision: C
1 A removable calibration tool is inserted by the operator into a calibration
bushing on the axis chosen for calibration, according to instructions on the
FlexPendant.
WARNING
Calibrating the robot with Axis Calibration requires special calibration tools
from ABB. Using other pins in the calibration bushings may cause severe
damage to the robot and/or personnel.
WARNING
The calibration tool must be fully inserted into the calibration bushing, until
the steel spring ring snaps into place.
2 During the calibration procedure, RobotWare moves the robot axis chosen
for calibration so that the calibration tools get into contact. RobotWare records
values of the axis position and repeats the coming-in-contact procedure
several times to get an exact value of the axis position.
WARNING
Risk of pinching! The contact force for large robots can be up to 150 kg.
Keep a safe distance to the robot.
© Copyright 20192020 ABB. All rights reserved.
6 Calibration
6.4.1 Description of Axis Calibration
Continues on next page
569