Brake Pedal Position Switch Test - Honda 2004 Odyssey Service Manual

Cruise Control Set/Resume/Cancel
Switch Test/Replacement
1. Remove the two screws (A), then remove the
switch (B).
2. Check for continuity between the terminals in
switch position according to the table.
• If there is continuity, and it matches the table, but
switch failure was indicated by the cruise control
unit input test, check and repair the wire harness
on the switch circuit.
• If there is no continuity in one or both positions,
replace the switch.
Terminal
Position
SET (ON)
RESUME (OFF)
CANCEL (ON)
B
A
Terminal side of male
terminals
1 2 3

Brake Pedal Position Switch Test

1. Disconnect the 4P connector from the switch (A).
A
2. Remove the brake pedal position switch.
3. Check for continuity between the terminals
according to the table.
• If the continuity is not as specified, adjust or
replace the switch or adjust the pedal height (see
page 19-6).
Terminal
Brake Switch
PRESSED
RELEASED
Terminal side of
male terminals
1 2 3 4
4-51 4-51