Honda Accord 2008 Manual page 1853

07/11/02 09:40:23 61TA0000_200_0286
Openers
Hood Release Handle Replacement
NOTE:
• Put on gloves to protect your hands.
• Take care not to scratch the body.
1. Remove the driver's kick panel:
• 2-door (see page 20-97)
• 4-door (see page 20-99)
2. Remove the bolts, then remove the hood release
handle (A).
０１
Fastener Locations
: Bolt, 2
3. Disconnect the hood opener cable (B) from the
hood release handle. Take care not to kink the cable.
4. Install the hood release handle in the reverse order
of removal, and note these items:
• Make sure the hood opener cable is connected
properly.
• Make sure the hood opens properly.
20-284 20-284
ＴＡ０８Ａ００Ｊ１８５３３２３２１０１ＫＢＡＴ００
B
6 x 1.0 mm
A
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
Trunk Lid Opener/Fuel Fill Door
Opener Replacement
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
• Put on gloves to protect your hands.
• Take care not to scratch the rear bumper.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Pry out the bottom edge of the front side cap (A) at
the notch with the trim tool to detach the hooks (B),
and release the hooks (C), then remove the cap
from the front door sill trim (D).
Fastener Location
: Bolt, 1
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
2. Remove the opener lock cylinder (E), and loosen
the bolt.
ＴＡ０８Ａ００Ｊ１８５７３５６０３３１ＫＢＡＴ００
E
C
A
B
B
B
B
D
０１