Honda Accord 2008 Manual page 1841

07/11/02 09:39:42 61TA0000_200_0274
Fenderwell
Front Splash Shield Replacement
NOTE:
• Put on gloves to protect your hands.
• Take care not to scratch the body.
• 4-door is shown; 2-door is similar.
1. Remove the front splash shield (A).
–1 Remove the clip (B) that secure the front splash shield to the body.
–2 Remove the clips (C) that secure the front inner fender (D) and the front splash shield to the body.
–3 From under the front bumper (E), remove the clips (F) that secure the front bumper, the front inner fender, and
–4 From under the front bumper, remove the clips (G) that secure the front bumper and the front splash shield to
–5 From under the body, remove the clips (H) that secure the front splash shield to the front subframe.
–6 Release the hooks (I) of the front splash shield, then pull the splash shield out.
＊０１
Fastener Locations
B, C, G, H
2. Install the splash shield in the reverse order of removal, and note these items:
• If the clips are damaged or stress-whitened, replace them with new ones.
• Push the clips into place securely.
20-272
ＴＡ０８ＡＥ４Ｊ１８５０００５６１１８ＫＢＡＴ００
the front splash shield to the body.
the body.
NOTE: To remove the clips, pry the inner clip up at the edge near the line (J) on its head.
: Clip, 14 F : Clip, 2
J J
J J
E
F
G
C
G
B
H
H
H
A
D
G
G
F
C
H
H
H
H
I