Honda Accord 2008 Manual page 1847

07/11/02 09:39:47 61TA0000_200_0280
Openers
Hood Opener Cable Replacement
NOTE:
• Put on gloves to protect your hands.
• Take care not to scratch the body and the related
parts.
1. Remove these items:
• Front grille cover:
– 2-door (see page 20- 255)
– 4-door (see page 20- 255)
• Front fender trim, left side:
– 2-door (see page 20- 258)
– 4-door (see page 20- 258)
• Front inner fender, left side as needed (see page
20-271)
• Kick panel, driver's side:
– 2-door (see page 20-97)
– 4-door (see page 20-99)
2. Disconnect the hood opener cable (A) from the
hood latch (B) (see page 20-283). Take care not to
kink the cable.
＊０１
Fastener Locations
: Clip, 6
3. Using a clip remover, detach the clips. Take care
not to kink the cable.
20-278
A
B
A
4. Disconnect the hood opener cable (A) from the
hood release handle (B) (see page 20-284). Take
care not to kink the cable.
C
B
5. Remove the grommet (C) from the body, then
remove the hood opener cable from the vehicle.
Take care not to kink the cable.
6. Install the cable in the reverse order of removal,
and note these items:
• If the clips are damaged or stress-whitened,
replace them with new ones.
• When installing the opener cable under the
dashboard, route the cable under the left engine
compartment wire harness (D).
ＴＡ０８Ａ００Ｊ１８５３３２３２００１ＫＢＡＴ００
D
A
A
＊０２